Velleman-projects K6714 Assembly instructions Instrukcja Użytkownika

Total solder points: 351 Difficulty level: beginner 1  2  3 ⌧ 4  5  advanced Universal relay card ILLUSTRATED ASSEMBLY MANUAL

10 Connect the phase to “0” and the Neutral to “125” or “220”, depending on the mains voltage. Normally the POWER ON LED should be lit now. In case n

11 Test and connections 2. Connect the board to the 10 channel, 2 wire remote control K8023 (see Fig. 2.0) : FIG 2.0 D5T1C3R13ZD1D4LD11D3C2VR1C4

12 Tips at malfunctions 18. Remedies in the case of malfunction caused by the relays If the relays are used to switch alternating voltage, it may be

13 19. INFORMATION FOR UPGRADING YOUR MODULE ! Component Quantity Description Order Nr. Diodes 8 1N41418 small signal diode. 1N4148 Resitors 16

14 PCB 20. PCB

15 21. Digital selection Diagram

16 VELLEMAN KIT NV Legen Heirweg 33 9890 Gavere Belgium Europe Info ?: http://www.velleman.be Modifications and typographical errors reserved © Velle

2 Features & specifications Features :  The relays can be controlled in different ways : direct control from open-collector outputs, TTL or CM

3 Assembly hints 1. Assembly (Skipping this can lead to troubles ! ) Ok, so we have your attention. These hints will help you to make this project s

4 ⇒ Use the check-boxes to mark your progress. ⇒ Please read the included information on safety and customer service * Typographical inaccuracies e

5 Construction  To use the relay card with 16 relay outputs, mount the components marked with (*) also (K6714-16). 1. Diodes (check the polarity)

6  R1 : 1K5 (1 - 5 - 2 - B) (*)  R2 : 1K5 (1 - 5 - 2 - B) (*)  R3 : 1K5 (1 - 5 - 2 - B) (*)  R4 : 1K5 (1 - 5 - 2 - B) (*)  R5 : 1

7 Construction  RY1 : VR15M121C  RY2 : VR15M121C  RY3 : VR15M121C  RY4 : VR15M121C  RY5 : VR15M121C  RY6 : VR15M121C  RY7

8 At the standard module K6714 as well K6714-16 have you the opportunity to noise-suppress every relay contact. First : mount the resistors to noi

9 Important If you want an electronic controller to be able to switch higher currents and at the same time you need an insulation between the control